DEWALT DWE7480 is a fantastic job site table saw that provides terrific cutting at reasonable price. It is really well designed and the pinion telescoping fence rails and rack enables you to adjust the fence very quickly and easily. Also, it provides much accurate fence adjustments in the least amount of time. Its base is composed of strong metal roll cage which is obviously far more durable than typical plastic bases and it provides much more protection against damage. It is highly well suited for job site work especially because of its light weight. Although, it’s not too light, but still light enough to be easily transported from one place to another.

It’s very easy to use this saw and while using it first time, you can set it up in less than ten minutes by looking at its documentation. The setup is neither complicated nor lengthy. It provides you high quality cutting but not hundred percent refined cutting. The blade is of low quality and if you replace its blade with high quality one, then surely the performance of this saw will be much higher. I have seen too many people complaining about the quality of its blade.

An Overview of DEWALT DWE7480 Job Site Table Saw

Now, I’ll show you an overview of various aspects of DWE7480 so that you can have more better and genuine opinion about this product.

Motor: DWE7480 is powered with 15 AMP motor which can reach 4800 RPM when moving without load or pressure. The motor is powerful enough to easily and smoothly cut variety of materials but gets slow down a bit when cutting thick and tough material. Overall, motor is good and there is no complaint yet received regarding the motor.

Protection: This saw guards well against several kinds of damage and it is tremendously protected by steel roll cage. Therefore, you can use it without any tension or fear in the rough atmosphere of the job site and you’ll be sure that there will be no damage to the blade shield and the fence.

Grip: DWE7480 incorporates two handed grip and the grip facility is so well designed that it provides highly balanced grip thus making it more easy and convenient to transport this saw.

Blade: As mentioned earlier, the blade is not of high quality and there are too many complaints regarding the blade. However, it is very easy to change the blade and it is suggested to replace its blade with a high quality variant to further increase the performance and efficiency.

Miter Gauge:It has very poor miter gauge which is almost useless. This part is also required to be replaced for better management and maximum output.

Noise: While working, it creates lot of noise which causes some disturbance in the work place.

The Pros and Cons of DEWALT DWE7480 Job Site Table Saw


  • Easy to adjust the fence in short time with high degree of accuracy
  • Powerful motor
  • High degree of durability and protection against damage and rough usage
  • Light weight makes its transportation more convenient
  • Highly well suited for job site work
  • Very short time required to setup
  • Extremely easy to operate and a new person can start operating it in minutes after going through the documentation
  • Convenient two handed and much balanced grip
  • Very easy to replace the blade


  • Very poor miter gauge
  • Creates lot of noise
  • Low quality blade

Opinion of Other Customers Regarding DEWALT DWE7480 Job Site Table Saw

It has feedback score of 4.5 out of 5, hence, it is well appreciated by majority of its users.


I’ll highly recommend this saw for various types of job site assignments.